The blower drive motor on some units may include oiling
cups at the top of the motor. There is no requirement to
oil the journals under normal operating conditions.
SECTION V - WALL THERMOSTAT IDENTIFICATION
FOR REMOTELY CONTROLLED CEILING ASSEMBLIES ONLY
Heat/Cool Thermostat Shown.
"Cool Only" Model Has No Reference
To Heat On Face Of Thermostat.
AND OPERATION
FIGURE 3
However, if lubrication to the unit is desired, use only SAE
20 non-detergent type oil. DO NOT OVER OIL - three to
four drops in each oil hole once a year is sufficient.
ELECTRONIC SINGLE STAGE
HEAT/COOL THERMOSTAT
^
Suggested Fuse To Protect Wiring Leading To Thermostat
ª
Not Found In "Cool Only" Applications
6
FIGURE 4