Mounting Of Elegance Junior Wall; Firing Instructions - Jydepejsen Elegance Junior Mode D'emploi

7. Mounting of Elegance Junior Wall

Drill a hole for the chimney.
If the stove is mounted with fresh air on
the back, drill a hole for this as well.
Hole for chimney.
Hole for fresh air supply.
Lift the stove onto the attached bracket.
Fasten the stove with the included bolt.

8. Firing instructions

It is crucial to ensure optimal up-draft in the chimney, at least 12 Pa.. It is essential that the chimney and the wood-burning
stove work together. In essence, the up-draft is affected by the length and area of the chimney but also its pressure
tightness. The least recommended chimney length is 3.5m and the most suitable cross-sectional area i 150-200cm² (140-
160mm in diameter). Your dealer or chimney sweep will be able to assist you with all chimney issues. If you have not used
your chimney for a long time, it should be checked for blockages before use. In some cases, it will be relevant to install a
damper device to control the up-draft in the stove.
The stove is designed and approved in accordance with EN13240 and NS 3058 for the combustion of split dry birchwood.
The water content in the wood should between 12% and 20%. Using wet wood results in tarry soot, environmental
nuisances and a bad fuel economy. Recently felled wood has a water content of approx. 60 - 70% and is completely unfit
for firing. Recently felled wood usually requires 1 year or more to dry. Regardless of its size, the wood should be split in
order to have at least one bark-free surface.
Requires 4 screws**, approved for the
respective wall type and able to carry the
weight of the stove.
** Not included