Maintenance - Ryobi P720 Manuel D'utilisation

WARNING:
Hybrid tools are always in operating condition. Therefore,
unit should always be in the OFF status, with the battery
pack removed and power cord disconnected, when not
in use. Do not leave light on while unattended. Failure to
follow these instructions could result in serious personal
injury.
WARNING:
Keep work light away from combustible materials. If
wrapped or in contact with fabrics, the work light lens
can produce sufficient heat to melt some fabrics. To avoid
serious personal injury, never allow the work light lens to
come in contact with anything.
TO HANG THE LED WORK LIGHT
See Figure 4, page 9.
WARNING:
Only hang or mount LED work light in an area where no
electrical wires, utility cables, pipes, or other obstructions
are located. Contact your local utility company or a
qualified electrician if you are unsure. Do not hang work
light from any electrical power cord. Ensure work light is
securely installed to prevent falling object hazard. Failure
to follow these instructions can result in electrocution,
electrical shock, or other serious personal injury.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
STORING THE WORK LIGHT
Store indoors in a dry, locked up place—out of the reach
of children with the battery pack removed and power cord
disconnected. Keep away from corrosive agents such as
garden chemi cals and de-icing salts.
NOTE: ILLUSTRATIONS START ON PAGE 8
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
Using the J Hook to hang the work light:
 Lift the J hook from the slot.
 Use the J hook to hang the work light. You may use
a screw to secure the work light in place. Do not
overtighten.
NOTE: Be careful not to hang the work light in such
a way that it prevents normal work light operation or
damages the cord.
Using the mounting holes to hang the light:
 Hang work light from sturdy location using screws in
mounting holes to secure in place. Do not overtighten.
NOTE: Be careful not to hang the work light in such
a way that it prevents normal work light operation or
damages the cord.
Using the cord retainer to hang the light:
 Hang the work light from a fence, hook the cord retainer
on fence
Mounting the work light to a tripod:
 Screw tripod into hole on the base of the light.
ADJUSTABLE HEAD
See Figure 4, page 9.
CAUTION:
Do not place hands or fingers between adjustable head
and frame when positioning work light to avoid pinching
your fingers or hands.
The work light head can be set in a variety of positions.
To switch base positions, loosen the knob. Adjust head to
desired position, tighten the knob.

MAINTENANCE

GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
7 – English