Maintenance - Ryobi P782 Manuel D'utilisation

Lampe hybride à trépied
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

POWER BUTTON (HIGH/LOW/OFF)
See Figure 9, page 11
The work light will be in the OFF position until the power
button is pressed.
 Connect the product to an AC or DC power supply.
 Press and release the button once to activate HIGH mode.
 Press and release the button again for LOW mode.
 Press and release the button a third time to turn the work
light OFF.
NOTE: This light is equipped with a low voltage indicator.
If the light flashes 3 times while a battery pack is installed,
this indicates a low charge condition. Four additional flashes
indicate that shutdown will follow quickly. Install a charged
battery pack and resume operation.
WARNING:
Hybrid tools are always in operating condition. Therefore,
unit should always be in the OFF status, with the battery
pack removed and power cord disconnected, when not
in use. Do not leave light on while unattended. Failure to
follow these instructions could result in serious personal
injury.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
NOTE: ILLUSTRATIONS BEGIN ON PAGE 10 FOLLOWING
OPERATION

MAINTENANCE

FRENCH AND SPANISH LANGUAGE SECTIONS.
WARNING:
Keep work light away from combustible materials. If
wrapped or in contact with fabrics, the work light lens
can produce sufficient heat to melt some fabrics. To avoid
serious personal injury, never allow the work light lens to
come in contact with anything.
ADJUSTABLE HEAD
See Figure 10, page 11.
CAUTION:
Do not place hands or fingers between adjustable head
and frame when positioning work light to avoid pinching
your fingers or hands.
The adjustable head can be set in a variety of positions.
Adjust the head as desired.
NOTICE:
The LEDs cannot be replaced. Any attempt to replace
the LEDs may damage the light.
STORAGE
Store indoors in a dry, locked-up place, out of the reach of
children, with the battery pack removed and power cord
disconnected. Keep away from corrosive agents such as
garden chemicals and de-icing salts.
9 – English

Publicité

Table des Matières
loading

Table des Matières