Keypad Lock - DeLonghi Ghibli Série Mode D'emploi

SETTING THE CURRENT DAY AND TIME
Before going on with the customized pro-
gram setup, check that the hour and day of
the week have been correctly set up. If this is
not the case, then press the "Standby" but-
ton followed by the "Mode" button and hold
them down until the number indicating the
day flashes.
Press the "+" and "-" buttons to set the day
of the week correctly (1=MON, 2=TUE,...7-
=SUN). Press the "Mode" button to confirm.
The hour is now flashing: use the "+" and "-"
buttons to set and confirm with the "Mode"
button.
Minutes are now flashing: repeat the same
EN
procedure.
SETTING THE PROGRAM
Now an hourly sequence can be set for each day. Start with
the first day. Choose by means of the "+" and "-" buttons, for
each hour, between the "Comfort" temperature (full bar) and
the "Night" temperature (empty bar).
T Night T Comfort
0h 2 4 6 8 10 12 14 16 18 20 22 24
Press "Mode" to confirm and repeat the procedure for every
day of the week.
The weekly program is now set, the appliance emits an
acoustic signal for confirmation.
4.2.8 OVERDRIVE (2h) FUNCTION
The "Overdrive (2h)" can be used to heat the room quickly.
Press the "2h" button to start the "Over-
drive (2h)".
The green LED "L1" on the control panel comes on.
T Night T Comfort
The set temperature disappears from the remote control
display.
The appliance heats at the maximum power for 2 hours, inde-
pendently from the temperature setting.
To deactivate "Overdrive (2h)" mode at any time, press the "2h"
button again, the "Mode" button or the "Standby" button.
Two hours after activation, the "Overdrive (2h)" function is
deactivated automatically and the appliance goes back to
the mode set previously.
The function can also be activated when the appliance is in
"Standby", in this case, when the two hours have elapsed the
radiator returns to "Standby".
4.2.9 FAN HEATER FUNCTION
Use the "Fan Heater" function to heat the room more quickly.
Pressing the button
LED "L1" on the control panel comes on.
After the button has been pressed, the icon
played and the 15 min. indication flashes for 5".
Within this period, the "+" and "-" buttons can be used to
modify the fan heater operating period between the fol-
lowing available times: 15 min. – 30 min. – 45 min. – 1 hour.
To turn the fan heater off, press the button
the time set on the remote control is reached, the "Fan Hea-
ter" function goes off automatically.

4.2.10 KEYPAD LOCK

It is possible to lock the remote control to avoid accidental
modifications.
Press simultaneously "+" and "Mode" buttons
for about 3 seconds to lock the keyboard.
The lock icon appears on the display
To unlock press simultaneously the two
buttons for about 3 seconds once again, the
Lock icon disappears from the display.
ATTENTION:
The "Child Safety" function is not available on this pro-
duct. If the "Child Safety" command is transmitted, the
appliance confirms reception of the signal and conti-
nues operating according to the previous settings. To
deactivate the icon from the remote control, press the
"Standby" button then the "-" button and hold both
down until the icon is no longer displayed.
46
turns the fan heater on.
is dis-
again. When
.