Chrono Mode; Night Mode - DeLonghi Ghibli Série Mode D'emploi

The temperature displayed is always the Comfort tempera-
ture, regardless of the currently selected "Pilot Wire" mode.
If the Pilot Wire is not connected, "Comfort" mode is selected
automatically.
4.2.4 COMFORT MODE
The "Comfort" temperature corresponds to the temperature
desired by the user.
Press the "Mode" button until the icon
displayed.
The green LED "L2" on the control panel comes on.
Modify the desired temperature, if nee-
ded, using the buttons "+" and "-". The
temperature can be choosen in the inter-
val between 7 °C and 32 °C.

4.2.5 NIGHT MODE

In Night mode the temperature set point must not be
higher than Comfort temperature set point. If the "Comfort"
temperature is set below the "Night" temperature, the latter
will be automatically adjusted accordingly.
Press the "Mode" button until the icon
displayed.
The green LED "L2" on the control panel comes on.
Modify the desired temperature, if nee-
ded, using the buttons "+" and "-".
The use of this operating mode is recommended in night-
time hours and in case no people is in the room for more
than 2 hours.
4.2.6 ANTI-FREEZE MODE
In "Anti-freeze" mode the temperature set point is fixed at
7 °C. The appliance starts heating when room temperature
goes under 7 °C and with low energy consumption it pre-
vents the room temperature to reach the freezing point.
Press the "Mode" button until the icon
displayed.
The green LED "L4" on the control panel comes on.
This operating mode is recommended when no people is in
the room for more than 1 day.

4.2.7 CHRONO MODE

In "Chrono" mode, you can select one of the three preset
chrono-thermostat programs or the custom program. The
latter lets you set various temperatures ("Comfort" and
"Night") over a 24 hour period for each day of the week.
CHOICE OF PROGRAM
Press the "Mode" button until the icon
is displayed. The green LED "L2" on the control
panel comes on. Then press the "Standby" but-
ton followed by the "+" button, holding both
together for at least 3 seconds.
The program code (P1, P2, P3 and P4) flashes.
Press the "+" and "-" buttons to set the pro-
gram. Press the "Mode" button to confirm.
PROGRAM P1
FROM MONDAY TO FRIDAY
is
SATURDAY AND SUNDAY
PROGRAM P2
FROM MONDAY TO SUNDAY
PROGRAM P3
FROM MONDAY TO FRIDAY
SATURDAY AND SUNDAY
PROGRAM P4 - CUSTOM
is
With the "P4" program, you can set different temperatures
("Comfort" and "Night") over a 24 hour period for each day
of the week.
45
is
HOURS MODE
0 - 6 Night
6 - 9 Comfort
9 - 16 Night
16 - 23 Comfort
23 - 0 Night
0 - 7 Night
7 - 23 Comfort
23 - 0 Night
HOURS MODE
0 - 7 Night
7 - 23 Comfort
23 - 0 Night
HOURS MODE
0 - 6 Night
6 - 9 Comfort
9 - 13 Night
13 - 23 Comfort
23 - 0 Night
0 - 7 Night
7 - 23 Comfort
23 - 0 Night
EN