Kichler Lucian II Manuel D'instructions page 8

HANGING THE FAN (continued)
Downrod
Step 8. Slip the coupling cover , canopy cover and canopy onto the downrod.
(Fig. 9)
Canopy
Thread the hanger ball onto the downrod, insert the cross pin through the
Canopy Cover
downrod and tighten. Now tighten the set screw. (Fig. 9)
Step 9. Lift the motor assembly into position and place the hanger ball into
Coupling Cover
the ceiling mounting bracket.
Set Screws
Rotate the entire assembly until the "Check Tab" has dropped into the
"Registration Slot" and seats firmly. (Fig. 10)
The entire motor assembly should not rotate (left or right) when seated
Retaining
properly. Hitch Pin
Clip
WARNING: Failure to reattach the cross pin and seat the "Check Tab" can
cause the fan to fall from the ceiling during operation. Take special care to
make sure this pin is reattached.
Fig. 9
Registration
Slot
Fig. 10
8 | KICHLER.COM