Garland CLEAN 330 E Manuel D'instructions page 27

Check that the electrical outlet and extension cord are
undamaged and that they fulfill the requirements for
this machine.
Tighten, repair or replace everything needed before
using the machine.
Do not use any accessory on this machine outside of
those recommended by us since its use could cause
damage to the user, machine, and people, animals
and things close to the machine.
6.3.2. TURNING ON AND OFF
Turning on the machine:
Place the switch in the "I" (ON) position.
Turning off the machine:
Place the switch in the "0" (OFF) position.
Do not start and stop the machine again and again
within a few seconds, or submit to the engine to an
important job, this will generate too much heat and
will decrease the life of your engine. We recommend
that whenever you stop the machine wait at least 5
seconds before turning it on.
6.3.3. VERIFICATION POINTS AFTER TURNING ON
It is important to pay attention to the possible
individual parts or the temperature of the machine.
If you detect any abnormality in the machine
immediately stop and check it carefully. In case of any
malfunction or problem take the machine for service
to be repaired. Under no circumstance should you
continue working if you notice that the machine is not
working correctly.
Do not use the machine if it is damaged or improperly
adjusted.
Caution – Keep filters clean efficiency of the
vacuum is largely dependent on the filter. A clogged
filter can cause overheating and possibly damagethe
cleaner. Check the filter periodically and replace as
required.
7. MAINTENANCE AND SERVICE
Unplug the machine before completing any
operation on the machine. Read the instruction
manual before doing any operation with the machine.
Do not ever attempt to do adjustments on the
machine if it is running. Perform all maintenance
of the machine while it is placed on a flat, cleared
surface.
Always perform the maintenance or service with the
power to the machine unplugged.
Keep the machine clean, especially the motor vent
windows.
Use only replacements suitable for this machine
in order to obtain a proper performance of the
machine. These replacements can be found at official
distributors of this machine. The use of other spare
parts can cause accidents or damage to the user and
people surrounding the machine.
Always readjust the machine on a flat, stable surface.
The tampering of the security devices, improper
maintenance, and replacement of elements with non-
original spare parts can cause injury.
7.1. MAINTANANCE AND CARE AFTER USE
Perform the following maintenance operations
and care when you have finished working with the
27/104
English