Weber Spirit SP310 Mode D'emploi page 18

GENERAL TROUBLESHOOTING
PROBLEMS
Burner does not ignite when you push the igniter
button.
Burner does not ignite, or flame is low in
high ( ) position.
Burner flame pattern is erratic.
Flame is low when burner is on high ( ) position.
Flames do not run the whole length of the
burner tube.
Burners burn with a yellow or orange flame, in
conjunction with the smell of gas.
Experiencing flare-ups.
m CAUTION: Do not line the slide-out
grease tray with aluminum foil.
Inside of lid appears to be "peeling."
(Resembles paint peeling.)
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
18
WWW.WEBER.COM
®
TROUBLESHOOTING
SOLUTIONS
Be sure that there is gas flow to the burners by attempting to match light your burners. Refer to "MAIN BURNER
IGNITION—Lighting with a Match." If match lighting is successful, the problem lies in the ignition system. Refer to
"MAINTAINING THE ELECTRONIC CROSSOVER
Be sure that wires are correctly inserted into terminals on igniter module. Check that the wires are connected to
terminals on igniter button under the control panel. Refer to "IGNITER MODULE WIRE GUIDE."
If a new battery is installed, confirm that battery's plastic wrapping has been removed. Verify that the battery is in good
condition and has been installed correctly. Refer to "MAINTAINING THE ELECTRONIC CROSSOVER
SYSTEM."
Fuel hose could be bent or kinked. Straighten fuel hose.
Clean burner ports that run down the entire length of burner tube. Refer to "ANNUAL MAINTENANCE."
Inspect spider/insect screens for possible obstructions. (Blockage of holes.) Clean spider/insect screens.
Refer to "ANNUAL MAINTENANCE."
Grill must be preheated with all burners on high for 10 to 15 minutes.
Clean the cooking grates and Flavorizer
The slide-out grease tray may be dirty and is not allowing grease to flow into catch pan. Clean slide-out grease tray.
The inside of the lid is porcelain enamel or stainless steel. It is not painted. It cannot "peel." What you are seeing is
baked-on grease that has turned to carbon and is flaking off. THIS IS NOT A DEFECT. Clean thoroughly. Refer to
"ROUTINE MAINTENANCE."
.
®
® IGNITION SYSTEM."
bars thoroughly to remove grease. Refer to "ROUTINE MAINTENANCE."
®
® IGNITION