Weber Spirit SP310 Mode D'emploi page 11

ALMOST READY TO GRILL
A quick-disconnect device
connects your grill to the gas
supply. After you have made
the connection, a leak check
will need to be performed.
CONNECTING TO THE GAS SUPPLY
CONNECTING THE FLEXIBLE HOSE TO
GAS SUPPLY
A) Starting from inside the cabinet, route the flexible gas
hose out of the opening in the rear panel (1).
B) Slide the collar of the quick-disconnect back (2).
C) Push male fitting of the hose into the quick-disconnect
and maintain pressure. Slide the collar closed (3). If it
does not engage or lock, repeat procedure.
This procedure will produce a gas joint. Gas will not flow
unless the quick-disconnect is properly engaged. To
disconnect the hose, push collar back and pull out the
plug. (This automatically shuts off gas.)
The natural gas hose was attached during the
manufacturing process. We recommend that the
hose-to-gas manifold connection be leak tested, following
guidelines in this Owner's Guide, prior to grill operation.
Note: Do not turn on gas source until you have performed
a leak check. Refer to "CHECKING FOR GAS LEAKS. "
1
1 Shutoff valve
2 Pipe nipple
3
Socket
NATURAL GAS HOSE CONNECTION
2 3 4
4 Dust covers
5 Male connection
6
Swivel connection
1
2
3
5
WWW.WEBER.COM
6
11
®