Samsung Pure Cycle WF231 Serie Informations Techniques page 2

ALIGNMENT AND ADJUSTMENTS
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
GENERAL ERROR FUNCTION
Error Code
NO
(Diagnostic Code
Error Image)
1 nd
2 LO
3 nF
4 FL
5 LE
6 1E
7 OE
8 dc
9 E2
[BingBang2] Technical_information_02830C-01_EN.indd 2
WARNING
Description
The water level fails to drop below the
Reset Water Level within 15 minutes.
Door fails to Unlock After 7 attempts.
When the filling Continues for more
than 40 minutes or there is no change
of water level for 6 minutes.
Door fails to lock after 7 attempts.
A water level lower than the Reset
water level is detected for 5 seconds
during the Wash/Rinse cycle.
Water Level Sensor Trouble. (When
the input signal from the water level
sensor is out of range, the unit will
send out beeping sounds and halts
the cycle.)
A fault is detected in the water level
sensor. Data (frequency) shows the
water level is at or above the overflow
water level. (When this condition
is detected, the machine will
automatically starts draining water
until the water level falls below the
reset water level)
Unbalance or cabinet bump is
detected during final spin, which
prevents the drum from spinning over
150 rpm. (Never exceeds 150 RPM due
to unbalanced load)
Jammed Key.(When key input signals
are coming out for more than 30
seconds, it is regarded as a jam.)
2
Corrective Action
Go to " Will Not Drain" Troubleshooting
Section.
Go to " Will Not Unlock"
Troubleshooting Section.
Go to " No Water Fill" Troubleshooting
Section.
Go to " Will Not Lock" Troubleshooting
Section.
Go to "No Water Fill" Troubleshooting
Section.
Go to "No Water Fill"
Troubleshooting Section
First check to see that all of water
valves are not stuck. If water valves
are OK, check water level.
Go to "Wet Clothes" Troubleshooting
Section.
Check all of keys. If A key is sensed
to be pressed, all keys will do not
respond.
2012-10-05 3:26:47