Installation; Power Supply; Installing The Camera - Abus TVIP70000 Manuel Utilisateur

3. Installation

Make sure that all accessories and articles listed above are present in the scope of delivery. An Ethernet
cable is required for camera operation. This Ethernet cable must meet the specifications of UTP Category 5
(CAT 5) and must not be longer than 100 meters.

3.1 Power supply

Before starting installation, ensure that the mains voltage and the rated voltage on the camera are identical.

3.2 Installing the camera

Firstly, undo the four screws to remove the dome
cover (see diagram on right, items 1 to 4).
The camera base plate is attached to the wall or
ceiling using two screws.
Ensure that the lens is directed towards the
area to be monitored.
Hold the camera in the desired position, mark both
holes on the surface, then drill the two holes. The
installation material is included in the scope of
delivery.
Cables can be laid at the side or through the ceiling
or wall. A break-out panel for feeding the cable is
located on the side of the housing if the cables are
laid at the side. This panel must be carefully
removed using pliers. Any remaining sharp edges
on the housing must be smoothed using a file.
Use the installation material provided (see diagram
on right, items 5 and 6) to fasten the camera in
place.
IMPORTANT!
The camera must be disconnected from the mains power during installation.
5
1
38
6
2
4
3