Kicker DX.1 Serie Manuel Du Propriétaire page 3

installation by using a KICKER ZISL as shown below. Either input method will provide a low-level output signal
at the RCA output, which effectively passes the audio signal to another amplifi er or component. Keep the audio
signal cable away from factory wiring harnesses and other power wiring. If you need to cross this wiring, cross it
at a 90 degree angle.
core conductor
source unit
high-level speaker
outputs
+
–
Install a fuse within 18" (45cm) of the battery and in-line with the power cable connected to your amplifi er. If you
ever need to remove the amplifi er from the vehicle after it has been installed, the ground wire should be the last
wire disconnected from the amplifi er--just the opposite as when you installed it.
Model External Fuse
(sold separately)
DX500.1 1 x 50 Ampere
DX1000.1 1 x 100 Ampere
woofer
24"
(60cm)
bare-metal
chassis ground
2010 DX Mono Amps RevD.indd 3 2010 DX Mono Amps RevD.indd 3
shield
Power/Ground Wire
4 Gauge
4 Gauge
GND REM +12V
POWER
PROTECTION
+
SPEAKER
external fuse
remote turn-on
(see page 5)
to amplifi er
KICKER ZISL
OR
KICKER Wiring Kit
PK4, CK44, ZCK44
PK4, CK44, ZCK44
-
18"
(45cm)
12V
battery
to amplifi er
source unit high-level
speaker outputs
11/10/2009 5:15:28 PM 11/10/2009 5:15:28 PM
3