Publicité
Les langues disponibles
Les langues disponibles
ERRORS
What should I do, if...
Error table
Problem
The dishwasher is not
working.
The drainage pump
does not shut off.
Problems with setting
up the connection
or other connection
problems.
Noise.
EN 24
If the appliance is not functioning well, this does not always mean that
it is faulty. Try to resolve the fault yourself first. If the recommendations
below do not solve your problem, telephone our service department.
Note!
Disconnect the appliance from the power supply before beginning
repairs. It is preferable if you remove the plug from the socket.
Potential causes
Fuse is faulty or the earthing
switch has been activated.
The power supply is not
switched on.
The water pressure is too low. Check whether the dishwasher is
The door of the dishwasher is
not closed properly.
The water is running over.
Various options depending on
the situation.
Some noises are normal.
Cutlery is rattling in cutlery
basket or something small has
fallen out of the basket.
The motor makes an unusual
noise.
A spray arm touches an item.
Solution
Replace the fuse or reset the isolating
switch. Remove other appliances that
are connected to the same group.
Make sure that the dishwasher is
switched on and the door closed.
Make sure that the plug is correctly
inserted into the socket.
correctly connected to the water
mains and that the tap is open.
Make sure the door is closed
properly.
The system is designed so that it
can automatically detect overflowing
water. In that instance, the appliance
shuts off the circulation pump and
switches on the drainage pump.
Look at etna.nl/connected.
Noise of rotating pump/washing
noises; the detergent compartment
opening.
Ensure that everything is loaded
securely in the dishwasher.
The pump is blocked. Contact an
installer.
Pause the program and re-arrange
the items so the spray arm is not
blocked when rotating.
Publicité
