Télécharger Imprimer la page

ETNA VWV242CWIT/E01 Mode D'emploi page 87

Publicité

Les langues disponibles

Les langues disponibles

USING YOUR DISHWASHER
Filling the rinse aid reservoir
1.
Open the reservoir cap.
2.
Carefully pour in the rinse-aid into its dispenser, whilst avoiding it to overflow.
3.
Close the reservoir cap.
Note: Clean up any spilled rinse aid with an absorbent cloth to avoid excessive foaming
during the next wash.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is designed to
adjust the consumption by the user. If the dishes are not drying properly or are spotted, select
a higher setting until your dishes are spot-free. Select a lower setting if there are sticky whitish
stains on your dishes or a bluish film on glassware or knife blades.
1.
Switch on the appliance.
2.
Within 60 seconds after step 1, press and hold the Program button for more than
5 seconds.
3.
Press the Delay button to enter the setting mode. The rinse aid indicator blinks.
4.
Press the Program button to select the proper setting according to your using habits. The
settings will change in the following sequence: D1->D2->D3->D4->D5->D1.
The factory setting is D3.
5.
Press the On/Off button to confirm the setting and to end the setting mode.
Setting
D1
D2
D3
D4
D5
Amount of rinse aid (ml)
1.2
2.4
3.6
4.8
6.0
EN 15

Publicité

loading

Ce manuel est également adapté pour:

Vwv242cwit