Assembly - QEP 22900Q POWER PRO 1 HP Manuel D'utilisation

PRODUCT SPECIFICATIONS
Input: 6.5 Amps
No-load Speed: 3600 RPM
Output: 1-Peak HP
Blade Diameter: 7 in. (180 mm)
Arbor: 5/8 in.
Rating: 120 Volts~60 Hz AC
Depth of Cut: 1-1/8 in. (29 mm)

ASSEMBLY

ASSEMBLY AND OPERATION INSTRUCTIONS
COMPLETELY BEFORE CONNECTING THE
SAW TO A POWER SOURCE OR TURNING THE
MOTOR ON.
UNPACKING
1 . Remove all packing materials from around
your saw .
2 . Carefully lift the saw from carton and place
it on a level work surface .
3 . Do not discard the packing materials until
you have carefully inspected the saw for
loose or damaged parts .
FOLLOW ALL OF THE
FIGURE 3
The following items are included in box with
your tile saw:
• Tile Wet Saw
• 7 in. Diamond Blade
• Blade guard
• Rip Guide
• Angle Cutting Guide
• Owner's Manual
4 . Inspect the saw carefully to make sure
that no breakage or damage has occurred
during shipping . If any parts are damaged or
missing, please call QEP Customer Service
at 866-435-8665
DAMAGED OR MISSING, DO NOT ATTEMPT
TO OPERATE THIS SAW. OPERATING THIS
SAW WITH DAMAGED OR MISSING PARTS
COULD RESULT IN POSSIBLE SERIOUS
PERSONAL INJURY.
INSTALLING THE BLADE
1 . Remove right cutting table .
2 . Remove baffle (see FIGURE 4)
– 5 –
IF ANY PARTS ARE