Product Specifications; Assembly; Installing The Blade - QEP 22400Q Mode D'emploi

PrOdUCt SPeCiFiCatiOnS

Input: 4 amps
No-load Speed: 4600 rpm
Output: 3⁄5-peak hp
Blade Diameter: 4 in. (100 mm)
Arbor: 5/8 in.
Rating: 120 volts~60 hz ac
Depth of Cut: 3⁄4 in. (19 mm)

ASSEMBLY

ASSEMBLY AND OPERATION INSTRUCTIONS
COMPLETELY BEFORE CONNECTING THE
SAW TO A POWER SOURCE OR TURNING THE
MOTOR ON.
UnPaCKinG
1 . Remove all packing materials from around
your saw .
2 . Carefully lift the saw from carton and place
it on a level work surface .
3 . Do not discard the packing materials until
you have carefully inspected the saw for loose
or damaged parts .
The following items are included in box with
your tile saw:
FOLLOW ALL OF THE
• Torque Master XT Tile Saw
• 4 in. Diamond Blade
• Blade guard
• Rip Guide
• 45° Angle Cutting Guide
• Clip on extension table
• Owner's manual
4 . Inspect the saw carefully to make sure that
no breakage or damage has occurred during
shipping . If any parts are damaged or missing,
please call QEP Customer Service at
866-435-8665
DAMAGED OR MISSING, DO NOT ATTEMPT
TO OPERATE THIS SAW. OPERATING THIS
SAW WITH DAMAGED OR MISSING PARTS
COULD RESULT IN POSSIBLE SERIOUS
PERSONAL INJURY.

inStaLLinG tHe BLade

1 . To fit the Cutting Blade, first carefully lift the
hinged section of the table top . Remove screw
from splashboard and remove the splash
board to allow access .
– 5 –
IF ANY PARTS ARE