Electrical And Motor Specifications; Troubleshooting - QEP 60084A Manuel D'utilisation

ELECTRICAL AND MOTOR SPECIFICATIONS

120 VOLT MOTOR SPECIFICATIONS
Volts
Cycle
RPM
Amps/Watts
Connect tile saw as close as possible to power source.
TO AVOID PERMANENT MOTOR DAMAGE YOU MUST USE THE CORRECT
EXTENSION CORD. NEVER USE MORE THAN ONE EXTENSION CORD AT A TIME.

TROUBLESHOOTING

Overheating of saw:
A. Turn saw off and let it rest until motor is cool to the touch.
B. Check and clean the ventilation slots, removing blockage and dirt.
The saw does not start:
A. Check that power cord is properly plugged in.
B. No power from outlet.
C. Switch is damaged.
120 V
60 CYCLE
n 3600 RPM
0
1.5 Amps
- 8 -