Installation Precautions - Urmet 1092/662 Mode D'emploi

Installation precautions

 Arrange the device in a well-ventilated place to prevent overheating.
 For the same reason, do not install sources of heat, such as radiators or hot air ducts. Keep
away from direct sunlight. Do not install in areas subject to excessive dust, mechanical
vibrations or shocks.
 Consider the working temperature of the unit (from 0°C to 40°C) and humidity range (from 10%
to 90%) before choosing the installation location. High differences in temperature with respect
to the specified working temperature range can damage the unit. Do not install the unit over
another unit which generates heat.
 Wait for a while before operating a device immediately after transporting it from a cold place to
a warm place and vice versa. Wait on average for three hours: this will allow the device to
adapt to the new ambient (temperature, humidity, etc.).
 Do not arrange this device on an unstable surface, such as a tottering or slanted table. The
device could fall causing injury or mechanical failures.
 Do not install the device in a place where it could be exposed to humidity or water. Do not
direct a jet of water onto the device: risk of fire, electrocution or mechanical failure.
 Stop using the device is water or other material should penetrate inside: risk of fire and
electrocution. Contact the retailer or authorised installer.
 Do not install the device in environments exposed to rain or humidity.
 Arrange a suitable circuit breaker and fuse upstream of the devices.
 Make sure that the rating plate data corresponds to the power specifications before connecting
the device to the mains.
INSTALLATION
Figure 1: side power
5
PART
1
2
3
4
5
DS1092-105
4 3
RS-485 line data output terminal board
DESCRIPTION
RS-485 line data input terminal board
Power connector
Power LED (steady)
For future applications
Figure 2: input / output side
1 2
7