Final Assembly - Whirlpool GLADIATOR GAMT41HWJG Instructions D'assemblage

Using two or more people, lift the mobile workbench up and onto the casters.
1.
Bumper Assembly
F4
F5
F4. 6 mm washer
F5. M6 hex-head
bolt
Using 6 mm hex head bolts (F5) (8) and 6 mm washers
(F4) (8), fasten a bumper to each corner of the cabinet.
Completely tighten all the fasteners.
NOTE: To keep from stripping the bolts, do not overtighten.
6

FINAL ASSEMBLY

WARNING
Excessive Weight Hazard
Use two or more people to move and assemble
workbench.
Failure to do so can result in back or other injury.
F5
F4
2.
Use, Remove and Replace
the Drawers
NOTE: The key locks all of the drawers. Use the drawer liners
to avoid scratching or damaging the drawers.
REMOVING THE DRAWER
Unload the contents from the drawer. Slide out the drawer as
far as it will go. Press the lever down on the right-hand track
and lift the lever up on the left track to release the drawer.
Pull the drawer out the rest of the way.
REPLACING THE DRAWER
Align the drawer guides with the receiving glides. Hold the
receiving glides firmly and insert the drawer guide.
NOTE: It is normal for the drawer to close tightly the first time
after it has been removed. Push the drawer in completely.
A
A. Lever