Assembly Instructions; Shelving Use Requirements - Whirlpool GLADIATOR EZ CONNECT Instructions D'assemblage

Shelving Use Requirements

Maximum weight limit is 1,000 lbs (454 kg) for each shelf, not
■
to exceed 5,000 lbs (2,268 kg) for the entire shelving unit.
WARNING
Excessive Weight Hazard
Use two or more people to move and assemble
shelving.
Failure to do so can result in back or other injury.
Unpack
NOTE: Use 1 person to assemble shelving and 2 people to
move it.
1. Remove and verify the contents. See the "Parts" section
so you can sort out all of the parts.
2. Dispose of/recycle all packaging materials.
Assemble & Complete
No tools or hardware required.
■
Can be assembled by 1 person.
■
IMPORTANT:
Determine shelf spacing before assembly.
■
NOTE: It is recommended to equally space the shelves from
top to bottom of the shelving unit and build it from the bottom
up. See "End Frames/Support Beams" illustration.
Prior to assembly, record model and serial numbers on the
■
included warranty page.
Support Beam Orientation
4

ASSEMBLY INSTRUCTIONS

End Frames/Support Beams
P6
P4
P3
P2
Tie Channels for Shelf Support
NOTES:
It is recommended to put beams at notch 1, 8, 14, 21, and
■
28 (counting from the bottom up). To keep shelving rack
balanced, keep 3 of the shelves on the bottom half of the
shelving rack.
All support beams need to be at the same height or the
■
shelves will not assemble correctly.