Publicité
Les langues disponibles
Les langues disponibles
3. Replace the bulb with one of the same
power (the maximum power is shown on
the light bulb cover)
4. Replace the light cover by sliding it into its
original position.
5. Reconnect the appliance.
6. Open the door and check if the light
comes on.
Technical data
Dimension of the recess
The technical information are situated in the
rating plate on the internal left side of the ap-
pliance and in the energy label.
Installation
Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the
appliance:
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
3. If necessary, replace the defective door
Height
Width
Depth
Climate
class
SN
N
ST
T
Removing the shelf holders
Your appliance is equipped with shelf retain-
ers that make it possible to secure the
shelves during transportation.
To remove them proceed as follows:
stallation".
gaskets. Contact the Service Force Cen-
ter.
1225 mm
560 mm
550 mm
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
17
Publicité
