OK. OLE 241 B-D4 Mode D'emploi page 27

Installing the Batteries to the Remote
1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
VGA
SPDIF
Switching On/Off
Switching the TV On
With power cord plug connected to the mains power
socket, the TV is in 'Standby' mode.
To switch the TV on from standby mode:
Press the " " button and the TV will switch to
standby mode. Then the standby LED lights up.
To switch on the TV from standby mode either:
a. Press the " " button, P+ / P- or a numeric button
on the remote control.
b. Press the middle of the "
By either method the TV will switch on.
Switching the TV Off
Press the " " button on the remote control or press
the standby " " button, so the TV will switch to
standby mode.
To turn off the TV completely, remove the power
cord plug from the mains power socket.
All manuals and user guides at all-guides.com
Note: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search,
Over Air Download or Timer is active. The LED can also blink
when you switch on the TV from standby mode.
When turned on for the first time, the "language
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Press the "
required language, press OK button to select. "First
Aerial or Cable
Time Installation" appears. Use "
set the required country, and press "
select Search Type (optional).
Use " " or " " to set the desired search type. Available
search types are Digital and analog, digital only and
analog only.
When set, press "
Use " " or " " to select the desired Teletext Language.
Next, select Scan Encrypted and set as Yes if you
want to scan coded stations.
" button on the TV.
Default PIN code can change depending on the
selected country. If you are asked to enter a PIN code
for viewing a menu option, use one of the following
codes: 4725, 0000 or 1234.
English - 26 -
First Time Installation
" or "
" to select Teletext Language.
" button to highlight the
" or " " button to
" button to