Webasto Cool Top Trail 20 Notice D'utilisation Et D'installation page 14

6 | Operating Instructions
Fig. 35 Setting the temperature
l Both the display of the remote control and the display of
the air distributor show the set temperature.
l The air conditioner confirms receiving each set value
change with a beep.
l You can set the temperature between 16 and 30 °C when
the unit is running.
l You cannot set the temperature in FAN
6.8 Setting the fan speed
Use the FAN button to set the fan speed level.
l The fan speed level directly influences the air flow volume.
l Each push on the FAN button changes the fan level in the
sequence as shown below.
AUTO indicates that the Automatic FAN mode is selected. In
this mode the fan speed adapts automatically. Automatic FAN
mode is only available in operation mode COOL or HEAT.
Fig. 36 Setting the fan speed
6.9 Setting the operation mode
Press the MODE button on the remote control to change the
operation mode. The remote control shows the selected icons.
l Each push on the MODE button changes the mode in the
sequence as shown below.
Fig. 37 Setting the operation mode
14 / 155
COOL mode
l In COOL mode the air distributor shows the
the vehicle will be cooled.
l Set temperature and fan speed can be selected manually.
l The compressor switches off when the set temperature is
reached, it automatically switches on again when the room
temperature setting is exceeded.
Fig. 38 COOL mode
DRY mode
l In DRY mode the unit is reducing the humidity inside the
mode.
vehicle.
l Set the temperature 1 °C lower than the current room tem-
perature.
l The air distributor shows the
Fig. 39 DRY mode
FAN mode
l In FAN mode indoor air is circulated through the vehicle
without heating or cooling.
l You can manually set the fan speed.
l The air distributor shows the
room temperature.
Fig. 40 FAN mode
symbol and
symbol.
C
icon as well as the current
9039408E_OI-II_Cool Top Trail 20-24