Publicité
Les langues disponibles
Les langues disponibles
Audio Adjustments
# To turn high pass filter off, press
MULTI-CONTROL again.
4
Push MULTI-CONTROL left or right to
select cut-off frequency.
50—63—80—100—125 (Hz)
Only frequencies higher than those in the se-
lected range are output from the front or rear
speakers.
Boosting the bass
Bass boost function boosts the bass level of
sound.
1
Press and hold SW/BASS to display
BASS BOOST setting mode.
2
Push MULTI-CONTROL up or down to
select a desired level.
0 to +6 is displayed as the level is increased or
decreased.
Note
You can also switch to this setting mode in the
menu that appears by using
MULTI-CONTROL.
Adjusting source levels
SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
! Settings are based on the FM volume level,
which remains unchanged.
1
Compare the FM volume level with the
level of the source you wish to adjust.
2
Display the audio menu.
Refer to Introduction of audio adjustments on
page 38.
3
Use MULTI-CONTROL to select SLA.
Black plate (41,1)
4
Push MULTI-CONTROL up or down to
adjust the source volume.
Each time MULTI-CONTROL is pushed up or
down, source volume increases or decreases.
+4 to –4 is displayed as the source volume is
increased or decreased.
Notes
! The AM volume level can also be adjusted
with source level adjustments.
! The built-in CD player and the multi-CD player
are set to the same source level adjustment
volume automatically.
! External unit 1 and external unit 2 are set to
the same source level adjustment volume
automatically.
<YRD5282-A/S>41
Section
09
41
En
Publicité
