Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION OF DRAIN LINE
1. Connect drain line tubing to drain connection point at back of unit (Fig.3).
2. Use hose clamp or supplied plastic ties to secure drain line tubing and provide a liquid tight seal (Fig.4).
Note: A floor drain should be in close proximity to final installation location as the drain line must slope
directly to the floor drain sump without any flow blockages.
REAR
Fig.3
INSTALLATION OF ICE MAKER ONTO ICE STORAGE BIN
Please refer to the Ice Maker's User Manual for complete installation instructions.
Interfacing of a DUURA ice bin with another manufacturer's ice maker may require the addition of an adapter
plate for the proper fit of these units with no leakage potential.
Note: A completed installation requires:
(1) 115 NEMA 5-15 power hook up of the modular ice maker.
(2) Connection of a 15 to 75 psig (pounds per square inch gauge) water supply line.
(3) Connection of the ice maker discharge and ice storage bin drain lines to the floor drain.
Fig.5
Part 1:
1. Locate flexible gasket included in the packaging with this storage bin.
2. Position gasket on top of storage bin. Be sure gasket is properly positioned in place in the groove at top of
storage bin. (Fig.5).
3. Place your selected ice-making unit on top of storage bin and make sure it is properly aligned with the sides
and back edge.
Drain connection
point (3/4")
Rear of unit
Top view of
Ice Storage Bin
SIDE
Fig.4
Flexible Gasket
Cut-out for ice to enter storage bin
5
Plastic Tie
Drain Line
Tubing
Publicité
