OHAUS Courier 5000 Mode D'emploi page 12

EN-8
3. OPERATION
3.1 Turning On/Off the Scale
To turn on the scale, press the On button. The scale performs a display test, and momentarily displays the
software version, the GEO value and then enters the last active weighing mode.
To turn the scale off, long press the Off button until
3.2 Setting the Display to Zero
The value of the display can be set to zero under the following conditions:
1. Automatically at Power On (Initial zero).
2. Manually press the ON/ZERO Off button.
3. Semi-automatically send the Zero command (Z or alternate zero command) by USB connection to a PC.
Before pressing the ON/ZERO Off button, please make sure that the scale is stable.
3.3 Changing the Units of Measure
To change the weighing unit, long press the Print Units button until the desired weighing unit appears on the
display.
NOTE: If the desired weighing unit is not shown, check if the unit is activated in the Unit menu (See section 4.5
Unit Menu).
3.4 Printing Data
Before you print out the displayed data with a printer or sending the data to a computer, please set the
communication parameters in the Print Menu (Refer to 4.7 Print Menu).
Press the PRINT Units button for sending the displayed data to the communication port.
3.5 Application Modes
Activating / Deactivating the Application Mode
Long press the Menu button until
1.
Release the Menu button, and
2.
C.A.L
NOTE:
3. Short press the No button several times until
Press the Yes button to enter the required application mode.
4.
5. Short press the No button several times until the desired selection appears on the display.
6. Press the Yes button, and
press the Yes button. If you want to deactivate the application mode, short press the No button until
appears on the display, then short press Yes button.
mM.E.N.U
7. Press
3.5.1 Weighing
This mode is the default factory setting, and it is used to determine the weight of the loads in the selected unit
of measure.
Entering the Mode and Starting to Weigh
1. Long press the button Function Mode until
2. Put the container on the scale. Once the value is stable, "*" will appear on the display.
3. Press the button Tare to tare. If the scale performs well, the value on the display is 0.
4. Put the load on the container and read the weight value of the load from the display. Once the value is
stable, "*" will appear on the display.
NOTE: You can check the value of the tare weight by long pressing the Tare button.
The Weighing configurations are defined below (Defaults in Bold).
Item
wWeIG
Weighing (
NOTE: The Weighing mode cannot be disabled if the scale is in the Weighing mode currently.
Find Quality Products Online at:
mM.E.N.U
C.A.L
appears on the display.
does not appear if CAL LOCK is on.
ON
appears on the display. If you want to activate the application mode, short
button once to exit.
Available Settings
)
On, off
GlobalTestSupply
www.
OFF
is displayed.
appears on the display.
mM.O.d.E
appears on the display.
wWEIG
appears on the display.
.com
Courier 5000
Comments
To enable or disable Weighing
sales@GlobalTestSupply.com
OFF