Air-O-Swiss AOS 7142 Mode D'emploi page 11

Operation 7142
K L I M
J
G
A
F
A) On/Off Button
You can switch the unit on or off by pressing button A. This
button is also used to reset the cleaning indicator light (by
holding down).
B) Hygrostat (setting the humidity level)
By pressing multi­functional button B (vertical) you can
set the desired humidity level in %. A relative humidity of
between 40 and 60% is recommended. The accuracy of
measurement is +/­ 5%. The unit will switch off when the
moisture level exceeds the desired setting. During selection
the target value is displayed. The display will automatically
show the current value after a few seconds.
All manuals and user guides at all-guides.com
C) Timer
Using multi­functional button C (horizontal), the operation
time can be set adjustable between 1 and 8 hours or CO
(continuous operation). Symbol G shows the operating pe­
riod that has been set (1h/2h/3h/4h/5h/6h/7h/8h/CO). The
display will automatically show the current value after a
few seconds.
H
D) Mist output (regulating mist output)
By repeatedly pressing button D you can control the mist
B
output. The LO/ME/HI display (symbol H) shows which of
the three levels (low/medium/high) you have selected.
C
E) Operation with pre-heating (warm mist)
D
Button E is used for switching the pre­heating on and off
(symbol I lights up). As a result, the water is pre­heated
to a temperature of 176 °F (80 °C) before entering the
E
nebulizer space. It takes approx. 10 to 15 minutes for the
water in the base to warm up. The mist now leaves the
humidifier at a pleasant temperature of 104 °F (40 °C). The
advantage of this is that the room temperature does not
drop and, in addition, it significantly improves the water
quality maintenance.
F) Automatic mode and Sleep mode
The automatic and sleep modes can be activated by pres­
sing button F. By pressing the button once, the automatic
function is switched on (symbol J appears on the display),
maintaining the optimum humidity subject to the tempera­
ture. Control takes place by means of output quantity and
pre­set target value. If the sleep function is switched on
(the symbol K appears on the display), the target humidity
is 60%; the operation time is automatically set at 6 hours;
the heating is switched on. In addition, the output quantity
is also controlled subject to the difference between the
target value and the actual value.
The Timer cannot be changed in either mode. If other but­
tons are pressed, the unit will no longer be in auto or sleep
mode.
G) Timer Indicator
H) Mist Output Indicator
I) Pre-heating Indicator
J) Automatic Mode Indicator
K) Sleep Mode Indicator
L) Empty indicator
The water level is easy to see, thanks to the transparent
water tank. The appliance also alerts you when the water
tank is empty. The empty indicator is illuminated (symbol L).
Please read the chapter «Filling the tank» for more informa­
tion. The Symbol L may stay illuminated for some seconds
with a refilled tank until the base is filled with water.
M) Cleaning indicator
If symbol M and «CLEAN» appear on the display, the appli­
ance should be cleaned as recommended by the manufac­
turer. This symbol comes on automatically every 2 weeks,
depending on the level of use. The display can be reset
by holding down button A until the light disappears.
e
11