Maintenance; Edi101; Ctv101 - Radiometer Analytical CTV101 Mode D'emploi

Table des Matières

Les langues disponibles

Maintenance

If the EDI101 electrode is to be used in samples containing corroding

agents, an inert gas (Nitrogen, Helium) flow must be applied through the

electrode bearings and contacts. Connect the tubing of the inert gas

bottle to the gas inlet (4) (see chapter "Description"). This operation

prevents the electrode bearings and contacts from being quickly

damaged by corrosion and/or clogging.

The EDI101 must be used in a vertical position or slightly sloping (motor

upwards and tip downwards).

The banana socket (3) holds the brush ensuring the contact. After a long

time of use (several hundreds of hours), it is recommended to replace

the contact brush (Radiometer Analytical Part no.: A35T630). Run in the

contact brush (3a) at 3000 rpm for 20 minutes after replacement.

The CTV101 requires a minimum of maintenance. The exterior surface

of the instrument should be cleaned with a soft and dry cloth. The use of

any solvent is forbidden as it can alter the marking. Any operation that

requires to open the CTV101 casing should only be performed by a

Radiometer Analytical service representative: contact our Radiometer

Analytical representative or:

Always use the original packaging of the CTV101 during

transportation.

RADIOMETER ANALYTICAL SAS

72, rue d'Alsace

69627 Villeurbanne CEDEX - France

Tél.: 33 0(4) 78 03 38 38

Fax: 33 0(4) 78 03 38 27

E-mail: radiometer@nalytical.com

Table des Matières

Edi101