Maintenance - Jydepejsen Country Mode D'emploi

As the steel panels will expand and contract during the firing/cooling phases, you may hear a crackling sound. This
is completely normal for sheet metal components, and cannot be considered a defect in the stove.
All Jydepejsen stoves are intermittent.
Refuelling onto a low fire bed
If there is insufficient burning material in the firebed to light a new fuel charge, excessive smoke emission can
occur. Refueling must be carried out onto a sufficient quantity of glowing embers and ash that the new fuel charge
will ignite in a reasonable period. If there are too few embers in the firebed, add suitable kindling to prevent
excessive smoke.
Fuel overloading
The maximum amount of fuel specified in this manual should not be exceeded, overloading can cause excess
smoke.
Dampers left open
Operation with the air controls or dampers open can cause excess smoke. The appliance must not be operated
with air controls or dampers door left open except as directed in the instructions.
!
NB: Only use wood with moisture content less than 20%

5. Maintenance

Gaskets and Vermiculite panels are wearing parts which need to be replaced from time to time – depending on
how much you use your stove. In some cases, you may need to replace them every year, while in others, replace-
ment every second or third year will suffice. As a rule of thumb, the gasket needs to be replaced when it has
become flattened and the door no longer fits tightly against the front of the stove. You can purchase sets of gasket
from your local dealer.
The Vermiculite panels must be replaced when they have worn thin, or when cracks – if any – become so wide that
you can actually see steel through them. If the panels are not replaced at such time, they will lose their capacity to
insulate and reflect heat.
We recommend that you use original spare parts.
Movable and mechanical parts (closing mechanisms, hinges etc) should be greased once a year with a heat-
resistant lubricant.
You should have your stove checked regularly by a qualified professional to ensure the optimal
!
function of the stove at all times. Do not make any unauthorised changes to the design of the
stove. Not only is this illegal, but it will also invalidate the stove guarantee and test results.
Replacing the gasket on the door
1. Remove the gasket from the door.
2. Press new gasket into the track.
GB [4,5]