Publicité
Les langues disponibles
Les langues disponibles
Problem
Extractor
hood does
No electrical supply
not turn on
Inadequate ventilation
The range hood and
cooktop are too far
away from each other
Check and make sure
My range
the tape holding down
hood has
the damper flaps at the
poor
vent hole are removed
performance
before use
Grease filters clogged
with grease build-up
Carbon filters clogged
with grease build-up
Motor is running but no
extraction
Check inside the range
hood for any loose
debris and remove
My range
If the noise is from the
hood is noisy
motor, please contact
our Customer Care
Service
Light is damaged
Lights are
not working
The light wire terminal is
loose
If problem persists after the above checks, please contact CIARRA
Customer Care Centre for assistance.
Possible Cause
31
Troubleshooting
Solution
Make sure that range hood
is plugged into powered
outlet. Test outlet with other
device if not working
Ensure that the kitchen is
sufficiently ventilated to
allow entry of fresh air
Optimal distance is
65~75cm above the cooktop
for best extraction
Remove the tape holding
down the damper
Clean the grease filters or
replace the grease filters
Replace new carbon filters
Please contact CIARRA
Customer Care Service
Please contact CIARRA
Customer Care Service
Replace with new LED lamp;
remove grease filters, reach
inside behind the control
panel and locate the wire
with clip behind the light
housing.
Reset the connection
EN
Publicité
