Oase HeatUp 25 Notice D'emploi page 4

- EN -
Scope of delivery
A
HeatUp
1 HeatUp
2 Instruction manual HeatUp
3 HeatUp holder with calibration tool
4 suction cups
INSTALLATION AND CONNECTION
NOTE
• Do not switch the unit on until it is immersed in water.
• The unit can be completely immersed in water.
• Ensure that the unit is immersed in water at least up to
the minimum immersion depth marking.
6
HeatUp 25/50/100/150/200/300/400
QTY
1
1
1
• Turn the
2
• Insert the
• Clamp the holder to the unit.
– Pay attention to the alignment
• Position the unit in the aquarium on a clean, smooth
NOTE
The desired water temperature can only be achieved
if the heating capacity of the heater is suitable for the
volume of water in the aquarium (→ Technical data)
and is positioned in an area with good water circulation.
B
temperature
controller to
the desired
temperature.
C
suction cups
into the holder
by twisting.
D
of the tab on the suction cup
(it should point upwards or to
the side).
surface in an area with good water circulation.
- EN -
7