Sauber VCE-127317.2 Mode D'emploi page 14

VCE-127317.2
USE AND FUNCTION
Assembling vacuum cleaner
Note:
Always remove the power plug from the wall outlet before assembling or removing accessories.
1. Attaching the flexible hose into the vacuum. Connect the flexible hose into the air intake duct; push in until
you hear a "click" sound, indicating it is in its locked position.
2. Fitting the tube to the curved wand/hose extension. Push the tube into the curved wand/hose extension.
3. Fitting the floor brush to the tube. Push the tube into the floor brush. Adjust the tube to the desired length.
Tip: By reducing the suction power you can move the floor brush easier on the floor. Set the suction power
to minimal for furniture, to medium for carpet and hard floors. Only use the maximum setting on hard floors
in combination with a brush for hard floors.
PARTS AND FUNCTION INTRODUCTION
1. Floor brush
2. Extension tube
3. Exhaust air valve
4. Suction hose
5. Suction hose connection
6. Carrying handle
7. On/off button
8. Dust barrel release button
9. Cord rewind button
10. Speed control button
11. Exhaust cover release button
12. Power cord and plug
13. Crevice nozzle
14. Textile nozzle
15. Accessory holder
- 13 -
EN