AudioSonic CL-1484 Mode D'emploi page 3

Location of controLs
1. ALARM 1 ON / OFF button
2. ALARM SET button
3. << / YEAR–MONTH–DAY button
4. >> / DST button
5. MODE button
6. ALARM 2 ON / OFF button
7. VOLUME knob
8. TUNING knob
9. LED DISPLAY
10. SPEAKER
11. AM/FM BAND switch
12. ON / OFF button
13. SNOOZE / SLEEP / NAP button
14. PROJECTION TIME 180° FLIP button
15. PROJECTION ON / OFF button
16. ALARM RADIO / BUZZER switch
17. PROJECTION UNIT
18. FOCUS ADJUSTMENT FOR
PROJECTION UNIT
19. AUX IN jack
20. RESET button
21. DISPLAY LIGHT DIMMER LOW / HIGH
/ AUTO OFF switch
22. AC POWER CORD
23. FM ANTENNA
24. BATTERY COMPARTMENT
25. RATING LABEL (bottom of unit)
9
1 2 3 4 5 6 7 8
11 12 13 14 15 16 17
18
19
10
20
23 22 21
25 24
PM Indicator
STANDBY Indicator
ALARM 1 Indicator
Power connection
Plug the AC POWER CORD (22) to a household outlet AC source. This unit is
equipped with a battery backup system, it requires a 3V CR2032 (flat) lithium
battery (not included). Insert the battery in the BATTERY COMPARTMENT (24),
making certain that the positive and negative (+ and -) battery terminals are
attached to the corresponding terminals on the plate in the battery compartment.
If an AC power failure occurs, the clock automatically switches to the battery
power supply, the clock and timer memory continue running. When the AC power
resumes, the clock switches back to AC again.
time, caLendar and aLarm settings
a. setting time and calendar
Press MODE button (5) in normal mode and keep depress over 2 seconds to enter
time set mode, after enter the setting mode, press MODE button (5) to change the
mode cycle as follows: Normal mode > Year > Month > Day > 12/24 H > RTC Hour
> RTC Min > Normal mode
action (during data adjustment):
• Press << / YEAR-MONTH-DAY button (3) to adjust data backward.
• Press >> / DST button (4) to adjust data forward.
• Keep depress << / YEAR-MONTH-DAY button (3) or >> / DST button (4) button
for 2 seconds to enable auto backward/forward.
B. setting alarm 1 and alarm 2
Press ALARM SET button (2) during normal mode and keep depress over 2 seconds
to enter the alarm set mode, after entering the setting mode, press the ALARM SET
button (2) to change the mode cycle as follows:
Normal mode > AL.1 Hour > AL.1 Min > AL.1 Weekday Alarm > AL.2 Hour > AL.2
Min > AL.2 Weekday alarm > Normal mode
Instruction Manual
TIME Indicator
EN
ALARM 2 Indicator
3