Bosch HGD43A150S Notice D'utilisation page 36

Igniting the gas burners
Always position the burner cap exactly onto the burner cup. The
openings in the burner cup must remain unobstructed at all
times. All parts must be dry.
Open the upper cooker cover. The upper cover must remain
1.
open whilst the cooker is in operation.
Turn the control for the required hotplate anti-clockwise to the
2.
symbol with the large flame
With the hotplate control pressed in, press the ignition button.
3.
Gas begins to flow out and the gas burner ignites.
Press and hold the hotplate control for 1-3 seconds. This
4.
activates the safety pilot. If the gas flame goes out, the gas
supply is automatically cut off by the safety pilot.
Set the required flame size. Between the Off
5.
— setting, the flame is not stable. Therefore, always choose a
setting between the large flame
If the flame goes out again, repeat the process from step 2.
6.
To finish cooking, turn the hotplate control clockwise to the
7.
Off position.
û
The hotplate control should not be turned to the ignition
position for longer than 15 seconds. If the burner does not light
within 15 seconds, wait at least one minute. Then repeat the
ignition process.
The gas burner does not ignite
If there is a power cut or if the ignition plugs are damp, you can
light the gas burners with a gas lighter or a match.
Electric hob
Electric hob, Heat capacity
heat settings
1 100 W
2 150 W
3 220 W
4 500 W
5 720 W
6 1000 W
Heating up the hotplate
To remove the new appliance smell, heat up the hotplate
without a saucepan at the highest level for 3 minutes.
Setting procedure for the electric hotplate
Set the heat setting using the hotplate knob for the required
hotplate.
Proceed as follows:
Open the top cooker cover. The cover must always be open
1.
during operation.
Turn the hotplate knob anti-clockwise to the required heat
2.
setting (1­6).
The hotplate is 145 mm in diameter. You can now begin
3.
preparing your food. Only use pans with a flat base. The
36
— .
û setting and the
— and small flame ˜ .
Suitable pot or pan diam-
eter for the electric hob
14.5 cm
14.5 cm
14.5 cm
14.5 cm
14.5 cm
14.5 cm
diameter of the pot or pan base should be the same as that
of the hotplate.
To switch off, turn the hotplate knob to position 0 (off).
4.
Heat setting 1 = lowest output
Heat setting 6 = highest output
Type of heating 1 or 2
Baking 6
2
Roasting 6
4
The indicator lamp lights up when the electric hotplate is
switched on.
:
Caution!
The electric hotplate cannot be switched on if the function
selector is set. If the function selector is set when the electric
hotplate is switched on, the power supply to the electric
hotplate is cut.
Important information about your electric hotplate
If the diameter of the pot or pan base is not the same as that of
the hotplate or if the pan base is not flat, energy will be used
unnecessarily. Any overflowing liquid will burn on and leave
stains that are difficult to remove.
Make sure that the pot or pan base is dry.
The electric hotplate must not be switched on if there is no pan
on it.
Due to the effects of heat, the metallic hotplate ring will
discolour over time. You can remove this discolouration by
cleaning the hotplate ring using the rough side of a sponge and
a cleaning agent. When cleaning, make sure that the sponge
does not come into contact with the hotplate.
Residual heat will still be present when the hotplate is switched
off. Keep children away from the appliance.
Make sure that the rotary knob for the hotplate is switched off
following a power cut.
Table – Cooking
Select the right pan size for each hotplate. The diameter of the
pot or pan base should be the same as that of the hotplate.
Cooking times may vary depending on the type of food, its
weight and quality. You yourself can best judge the optimal
cooking time.
Use as little water as possible when cooking, so that the food
retains its vitamins and minerals. Select short cooking times so
that the vegetables remain firm and full of nutrients.
Depending on amount
Start the cooking process
Continue the cooking process,
setting high or low as required
Heat the oilStart the frying pro-
cess
Continue the frying process