Publicité
Mechanical installation
3. Slightly turn the sleeve bolts (9) using an open end spanner.
-
If the air gap is too large, screw into the stator (1.1).
-
If the air gap is too small, screw them out of the stator (1.1).
-
A 1/6 turn will change the air gap by approximately 0.15 mm.
4. Tighten the screws (10) (for torques, see table
5. Check the air gap "s
6. Repeat the adjustment procedure if the deviation of "s
4.5
Manual release
NOTICE
❚ The manual release is designed for activation via a Bowden cable.
❚ For activation without a Bowden cable, the lever has to be extended.
❚ An individual brake circuit can only be released electrically.
The manual release is mounted when the double-spring-applied brake is installed. No power is applied to
the brake.
1. Mount the first rotor (3), the first complete stator (1), and the second rotor (3A) according to section 4.4.1,
steps 1 through 12 (
4.5.1
Components of the manual release
12.8
12.11
12.1
Fig. 13
Manual release
12.1 Manual release lever
12.5 Pressure spring
INTORQ | BA 14.0196 | 04/2016
" near the screws (10) using a feeler gauge, ("s
L
23 and 26).
12.8A
12.5
12.14
16).
" is too large.
LN
12.8 Lock nut
12.11Clip
"
16).
LN
12.14
Tension rod
29
Publicité
