Roland VS-1880 Mode D'emploi page 9

1
Before installing the VS8F-2, turn off the power of the VS-1880
and all connected devices, and disconnect all cables from the
VS-1880.
2
Turn the VS-1880 on its back, and remove only the screws
shown in the following diagram.
3
Inside, there are two connectors and six resin pins. Insert the
connectors of the VS8F-2 into the internal connectors, and
simultaneously insert the resin pins into the holes of the
VS8F-2 to fasten the unit in place. Be careful not to touch the
lithium battery of the VS-1880.
fig.1-05.e
4
Use the screws that you removed in step 2 to fasten the cover
back in place. This completes installation of the effect
expansion board.
Préparatifs
If you are installing only
one effect expansion board,
connect it to EFFECT A.
9