Publicité
Les langues disponibles
Les langues disponibles
3. Take special care to keep the ventilation inlets /outlets free from obstruction. Cleaning
with a soft brush followed by a compressed air jet will usually be sufficient to ensure
acceptable internal cleanliness.
4. Wear eye protection when carrying out cleaning.
Empty the fuel
1. Screw off the fuel tank cap.
2. Pour fuel into an appropriate container thoroughly.
3. Press the fuel pump several times to pump the residual fuel into fuel tank.
4. Pour fuel again.
5. Place the machine on even and stable surface.
6. Reinstall the fuel tank cap.
ANGLE TRANSMISSION(Fig.22)
Lubricate with lithium-based grease.
Remove the screw (1) and put in the grease, turning the shaft manually until
grease emerges, then replace the screw (1).
REPAIRS
Only an authorized service centre should repair the machine.
Problem
Check
Fuel at the
carburetor
The engine
stalls, is
Fuel at the
difficult to
cylinder
start or does
not start
Sparks at
the spark
plug
electrodes
GB
Fig.22
Condition
The fuel does not arrive
at the carburetor
The fuel does not arrive
at the cylinder
There is fuel in the
exhaust
There is no spark
24
Cause
Solution
Fuel filter
Clean or replace
blocked
Fuel supply
Clean or replace
blocked
Ask your distributor for
Carburetor
advice
Ask your distributor for
Carburetor
advice
Open the throttle valve
Clean or replace the air
The fuel mixture
filter
is too rich
Ask your distributor for
advice
Switch in "O"
Set the switch to the ON
position
position (Run)
Electrical
Ask your distributor for
problem
advice
Locked switch
Publicité
