Levelling - Bertazzoni REF75PIXL Guide D'installation

Do not use extension cords and/or multiple adapters
for the power supply connection.
ELECTRICAL AND WATER SUPPLY BEHIND THE UNIT
INTEGRATED SERIES
E
W
Electrical connection
Water connection
Back of appliance
Operate as follows:
> Unwind the electric cable and connect it directly to
the wall socket.
> Make sure the appliance is in the Stand-by condition
and that all lights are off; should it be not so press the
Unit button to switch it off.
>
Push the 1/4" source waterline fully into the elbow
connector thenthread the elbow adapter to the sole-
noid at the back of the appliance.
Firmly tighten with fingers - a tool /wrench should not
be needed to make a proper seal.
Turn on the water and ensure all connections are not
leaking prior to pushing the unit into the niche.

3.3 Levelling

Adjust the appliance level by means of the front level-
ling feetand the rear adjustable wheels.
Operate as follows:
> The grille should ship taped to the back of the ap-
pliance. If by chanceit is already in place, remove the
grille (it is kept in position by magnets), adjust the
height of the levelling feet
(3/4") wrench.
> Then adjust the height of the rear wheels by turning
the front adjusting bolts
clockwise as it may be required. (Do not use power
drivers with high torque settings for this step as it
E
could damage the levelling mechanism)
W
> Mount the lower ventilation grille only after the unit
is finally levelled in the niche.
www.universal.bertazzoni.com
[ 1 ] by means of a 17 mm
[ 2 ] clockwise or counter-
2
2
1
1
EN
9