Publicité
Les langues disponibles
Les langues disponibles
3. OPERATION
UK
3.16 TROUBLESHOOTING
PROBLEM
The appliance does not come on
The appliance works for a short time
only
The appliance works, but does not
cool the room
During operation, there is an
unpleasant smell in the room
The appliance does not operate for
about three minutes after restarting it.
The following message appears on
the display:
TAC-24WC
42
CAUSE
● There is no current
● It is not plugged into the mains
● The internal safety device has
tripped
● Here are bends in the air exhaust
hose
● Something is preventing the air
from being discharged
● Windows, doors and/or curtains
open
● There are heat sources in the room
(oven, hairdryer, etc)
● The air exhaust hose is detached
from the appliance
● The technical specification of the
appliance is not adequate for the
room in which it is located
● Air filter clogged.
● The internal compressor safety
device prevents the appliance from
being restarted until three minutes
have elapsed since it was last turned
off.
● The appliance has a self diagnosis
system to identify a number of
malfunctions
SOLUTION
● Wait
● Plug into the mains
● Wait 30 minutes, if the problem
persists, contact your service center
● Position the air exhaust hose
correctly, keeping it as short and
free of curves as possible to avoid
bottlenecks
● Check and remove any obstacles
obstructing air discharge
● Close doors, windows and curtains,
bearing in mind the "tips for correct
use" given above.
● Eliminate the heat sources
● Fit the air exhaust hose in the
housing at the back of the appliance.
● Ask to your distribuitor.
● Clean the filter as described above
● Wait. This delay is part of normal
operation
● See the SELF-DIAGNOSIS Chapter
Publicité
