AEG SANTO Z 9 12 03-6i Notice D'utilisation page 31

Problem
The compressor operates
continually.
The compressor does not
start immediately after
pressing theTURBO
COOLMATIC button, or
after changing the tem-
perature.
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Temperature cannot be
set .
The temperature in the
appliance is too low/high.
The temperature in the
refrigerator is too high.
Possible cause
The temperature is not set cor-
rectly.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
The compressor starts after a pe-
riod of time.
During the automatic defrosting
process, frost defrosts on the
rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
TURBO COOLMATIC function
switched on.
The temperature regulator is not
set correctly.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
What to do if...
Solution
Set a higher temperature.
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
This is correct.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Switch off TURBO COOLMATIC
manually, or wait to set the tem-
perature until the function has
reset automatically. Refer to
"TURBO COOLMATIC function"..
Set a higher/lower temperature.
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
31