Télécharger Imprimer la page

AEG SANTO Z 9 12 03-6i Notice D'utilisation page 22

Masquer les pouces Voir aussi pour SANTO Z 9 12 03-6i:

Publicité

Les langues disponibles

Les langues disponibles

22
Control panel
• This product must be serviced by an authorized Service Centre, and only genuine spare
parts must be used.
Environment Protection
This appliance does not contain gasses which could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The appliance shall not be discarded together
with the urban refuse and rubbish. The insulation foam contains flammable gases: the
appliance shall be disposed according to the applicable regulations to obtain from your
local authorities. Avoid damaging the cooling unit, especially at the rear near the heat
exchanger. The materials used on this appliance marked by the symbol
Control panel
1
1
Fridge Pilot light
2
Fridge ON/OFF switch
3
Fridge temperature regulator, + button
4
Fridge temperature indicator
5
Fridge temperature regulator, - button
6
TURBO COOLMATIC indicator
7
TURBO COOLMATIC button
Switching on the fridge
1. Insert the plug into the mains socket.
2. Press ON/OFF switch .
3. The Pilot Light will light up.
Switching off the fridge
1. Keep ON/OFF switch pressed for more than 5 seconds.
2. After that, a countdown of the temperature from -3 -2 -1 will be shown. When "1"
appears the fridge is turned off. The temperature indicator switches off. The Pilot light
switches off.
Temperature setting buttons
The temperature is adjusted using the temperature setting buttons. These buttons are con-
nected to the temperature indicator.
• The temperature indicator is switched over from the indicator of the ACTUAL tempera-
ture (Temperature indicator is illuminated) to the indicator of the DESIRED temperature
(Temperature indicator flashes) by pressing one of the Temperature setting buttons.
2
3
4
5
6
7
are recyclable.

Publicité

loading