AEG SANTO Z 9 12 03-6i Notice D'utilisation page 23

• Each time one of the two buttons is pressed again the DESIRED temperature is adjusted
by 1°C. The DESIRED temperature must be reached within 24 hours.
If neither button is pressed, the temperature indicator automatically switches back after a
short period (approx. 5 sec.) to the indicator of the ACTUAL temperature.
DESIRED temperature means:
The temperature that has been selected for inside the fridge. The DESIRED temperature is
indicated by flashing numbers.
ACTUAL temperature means:
The temperature indicator shows the current temperature inside the fridge. The ACTUAL
temperature is indicated with illuminated numbers.
Temperature indicator
The temperature indicator shows several information:
• During normal operation, the temperature currently present in the fridge (ACTUAL tem-
perature) is displayed.
• When the temperature is being adjusted a flashing display indicates the fridge temper-
ature currently set (DESIRED temperature).
When changing the temperature setting wait about 24 hours until the temperature display
has stabilised.
Temperature regulation
To operate the appliance, proceed as follows:
1. Set the required temperature by pressing the corresponding temperature regulator. The
temperature indicator will immediately show the changed setting (DESIRED tempera-
ture) and the temperature indicator flashes.
2. Each time the temperature regulator is pressed the DESIRED temperature is adjusted
by 1 °C. The DESIRED temperature must be reached within 24 hours.
3. Once the required temperature has been set, after a short period (approx. 5 sec.) the
temperature indicator will show again the current ACTUAL temperature inside the cor-
responding compartment. The temperature indicator will change from flashing to con-
tinuous illumination.
For a correct storage of the food the following temperature should be set:
• +5 °C in the fridge
When the setting is changed, the compressor does not start immediately if automatic
defrosting is currently taking place. As the storage temperature within the fridge is reached
quickly you can store food immediately after switching on.
TURBO COOLMATIC function
The TURBO COOLMATIC function is suited for quick cooling of large quantities of goods in
the refrigerator.
To activate the function, do these steps:
1. Press the TURBO COOLMATIC button.
2. The TURBO COOLMATIC indicator switches on.
The TURBO COOLMATIC function now provides for intensive cooling. A DESIRED tempera-
ture of +3°C is automatically selected.
The TURBO COOLMATIC function is ended automatically after a period of 6 hours.
You can deactivate the function at any time:
Control panel 23