Kärcher 1.667-291 Mode D'emploi page 14

Device elements
1 Electrodes
2 Suction hose
3 Push handle
4 Suction head lock
5 Wheel
6 Dirt receptacle
7 Suction head
8 Steering roller
9 Suction support
10 Steering roller bow
(NT 65/2 only)
11 Floor nozzle
12 Suction tube
13 Main switch
14 Carrying handle
15 Filter cover
16 Button for filter shake off system
17 Hose switch
18 Bender
19 Drain hose
20 Storage for floor nozzle
21 Holder for suction pipes
22 Power cord
23 Holder for crevice nozzle
24 Cable clamp
25 Nameplate
26 Filter dedusting
27 Flat fold filter
28 Tilting chassis
(NT 75/2 only)
29 Container handle
(NT 75/2 only)
Colour coding
The operating elements for the cleaning
–
process are yellow.
The controls for the maintenance and
–
service are light gray.
Start up
Caution
The flat pleated filter must always be in
place while vacuuming.
Dry vacuum cleaning
To vacuum fine dust, you can also use
–
an additional paper filter bag, a fleece
filter bag (option) or a membrane filter
(option).
Installing the paper filter bag/fleece filter bag
Illustration
 Release and remove the suction head.
 Insert the paper filter bag, fleece filter
bag (option) or membrane filter (option).
 Insert and lock the suction head.
Wet vacuum cleaning
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Remove the paper filter bag/fleece filter bag
If the appliance is used to vacuum wet
–
dirt, the paper filter bag, the fleece filter
bag (option) or the membrane filter (op-
tion) must always be removed.
It is recommended to use a special filter
–
bag (wet) (see Filter systems).
Drain off dirt water
Caution
Please observe the local provisions regard-
ing the wastewater treatment.
Appliance with metal container:
Illustration
Appliance with plastic container:
Illustration
 Drain off dirty water through the drain-
age hose.
Emptying the container fully
 NT 75/2 Ap Me Tc only:
Illustration
 Lock parking brake.
 Hold the container at the handle and tilt
it by raising it.
 Empty the container fully.
 Fold the container back into its original
position.
 Release parking brake.
– 2
EN 13