Télécharger Imprimer la page

HomeMatic IP HmIP-ESI-LED Notice D'installation Et D'emploi page 22

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
Troubleshooting
Caution! There is a risk of explo-
sion if the battery is not replaced
correctly. Replace only with the
same or equivalent type. Never
recharge non-rechargeable bat-
teries. Do not throw the batteries
into a fire. Do not expose batteries
to excessive heat. Do not
short-circuit batteries. There is a
risk of explosion
After replacing the batteries, you
may need to update the meter
reading to display the correct data
again.
8 Troubleshooting
8.1 Weak batteries
Provided that the voltage value per-
mits it, the device will remain ready for
operation even if the battery voltage is
low. Depending on the particular load,
it may be possible to send transmis-
sions again repeatedly once the batter-
ies have been allowed a brief recovery
period. If the voltage drops again while
sending, this will be displayed in the
Homematic IP app and on the device
(see „8.3 Error codes and flashing se-
quences" on page
replace the empty batteries with two
new ones
(see „7 Changing the batter-
ies" on page
21).
23). In this case,
8.2 Duty cycle
The duty cycle is a legally regulated
limit of the transmission time of de-
vices in the 868 MHz range. The aim
of this regulation is to safeguard the
operation of all devices working in the
868 MHz range.
In the 868 MHz frequency range we
use, the maximum transmission time of
any device is 1% of an hour (i.e. 36 sec-
onds in an hour). Devices must cease
transmission when they reach the 1%
limit until this time restriction ends.
Homematic IP devices are designed
and produced with 100% conformity to
this regulation.
During normal operation, the duty
cycle is not usually reached. However,
repeated and radio-intensive pairing
processes mean that it may be reached
in isolated instances during start-up
or initial installation of a system. If the
duty cycle is exceeded, this is indicated
by one long red flashing of the device
LED (A), and may manifest itself in the
device temporarily working incorrect-
ly. The device starts working correctly
again after a short period (max. 1 hour).
22

Publicité

loading