HomeMatic IP HmIP-ESI-LED Notice D'installation Et D'emploi page 16

Scope of delivery
1 Scope of delivery
1x Interface for energy sensors
1x LED energy sensor
2x Double-sided adhesive strips
2x 1.5 V LR6/Mignon/AA batteries
1x Operating manual
2 Information about this
manual
Please read this manual carefully be-
fore operating your Homematic IP
components. Keep the manual so you
can refer to it at a later date if you need
to. If you hand over the device to other
persons for use, please hand over this
manual as well.
Symbols used:
Important! This indicates a ha-
zard.
Note. This section contains additi-
onal important information!
3 Hazard information
Do not open the device. It does
not contain any parts that need to
be maintained by the user. In the
event of an error, please have the
device checked by an expert.
We accept no liability for damage
to property or personal injury
caused by improper use or the
failure to observe the hazard
warnings. In such cases, all war-
ranty claims are void. We accept
no liability for any consequential
damage.
For safety and licensing reasons
(CE), unauthorized change and/or
modification of the device is not
permitted.
The device may only be operated
in dry and dust-free environment.
It must be protected from the
effects of moisture, solar or other
methods of heat radiation, exces-
sive cold and mechanical loads.
The device is not a toy: do not
allow children to play with it. Do
not leave packaging material lying
around. Plastic films/bags, pieces
of polystyrene, etc. can be dan-
gerous in the hands of a child.
The device must only be operated
within residential buildings.
Using the device for any purpose
other than that described in this
operating manual does not fall
within the scope of intended use
and will invalidate any warranty or
liability.
16