HomeMatic IP HmIP-ESI-LED Notice D'installation Et D'emploi page 18

General system information
5 General system information
This device is a part of the
Homematic IP Smart Home system and
communicates via the Homematic IP
wireless protocol. All devices of the
Homematic IP system can be config-
ured comfortably and individually with
a smart phone via the Homematic IP
app. Alternatively, you have the option
of operating Homematic IP devices via
the CCU3 or in conjunction with many
partner solutions. The available func-
tions provided by the system in com-
bination with other components are
described in the Homematic IP User
Guide. All current technical documents
and updates are provided at
www.homematic-ip.com.
6 Start-up
Only put the cover (B) on once
you have completed the mount-
ing and installation work.
6.1 Pairing
Please read this entire section
before starting the pairing proce-
dure.
First set up your Homematic IP
access point using the
Homematic IP app so that you can
use other Homematic IP devices
in the system. For further informa-
tion, please refer to the operating
manual of the access point.
So that the device to be integrated into
your system and to communicate with
other Homematic IP devices, it must
first be paired on the Homematic IP
access point.
For pairing, proceed as follows:
• Open the Homematic IP app on
your smart phone.
• Select the menu item "Add device".
• Remove the cover (B) to open the
battery compartment (F).
• Pull the insulating strip out of the
battery compartment (F).
• The pairing mode is active for 3
minutes.
You can start the pairing mode for
a further 3 minutes by pressing
the system button (A) briefly.
18