HomeMatic IP HmIP-ESI-LED Notice D'installation Et D'emploi page 21

Changing the batteries
• Finally, insert the sensor connector
(H) on the underside of the HmIP-
ESI into the connection port (E) un-
til it audibly clicks into place.
655133 kWh
7 Changing the batteries
If an empty battery is displayed in the
app or on the device
codes and flashing sequences" on page
23), replace the used batteries with
two new LR6/Mignon/AA batteries. You
must observe the correct battery po-
larity.
To replace the device batteries, please
proceed as follows:
• When mounted, the cover (B) can
be removed by pressing in the up-
per and lower sides and pulling the
cover (B) forward
(see illustration).
• When not mounted, the cover cap
(B) can be removed by pressing in
the upper and lower sides with one
hand. At the same time, take hold
of the rib of the electronics unit (G)
on the rear side of the HmIP-ESI
with your other hand and pull it out
of the cover
(see
(see „8.3 Error
illustration).
• Remove the used batteries.
• Place the two new 1.5 V LR6/Mi-
gnon/AA batteries in the battery
compartment (F) in accordance
with the polarity markings.
• After inserting the batteries, pay
attention to the flashing sequen-
ces of the LED
and flashing sequences" on page
23).
• Put the cover (B) back onto the
mounted electronics unit (D), en-
suring that it latches fully into
place.
Once the batteries have been inserted,
the device will perform a self-test for
approx. 2 seconds. Afterwards, ini-
tialisation is carried out. The LED test
display will indicate that initialisation
is complete by lighting up orange and
green.
(see „8.3 Error codes
21