Publicité
Les langues disponibles
Les langues disponibles
display "nn" followed by the two numbers of the
month. With the keys
possible to set the current month.
Press the
key to memorise the date and
move on to changing the day: the screen will
display "dd" followed by the two numbers for the
day. With the keys
possible to set the current day.
Press the
key to memorise the date and
move on to changing the time: the screen will
display "hh" followed by the two numbers for the
hour. With the keys
possible to set the current hour.
Press the
key to memorise the entry and
move on to changing the minutes: the screen will
display "nn" followed by the two numbers of the
minutes. The time is displayed in a 24 hour
format. Using the
possible to set the correct value.
Press and release the
operate for 15 seconds: the
To exit the procedure early press and release the
key.
Viewing the temperature probes
Make sure the keyboard is not locked.
Press the
key for 1 second: the screen
displays the letters "rtc".
Press the
key: the screen will display the
temperature read by the cold room probe.
Press the
key: the screen displays the
letters "Pb2" (evaporator probe). Press the
key to view the value read by the evaporator
probe.
and
it is
and
it is
and
it is
and
keys it is
key or do not
LED will turn off.
Press the
key: the screen displays the
letters "Pb3" (condenser probe). Press the
key to view the value read by the condenser
probe.
To exit the procedure press the
screen will display the temperature read by the
cold room probe again.
HACCP Alarms
The tool is capable of memorising up to 9 HACCP
alarms, after which the most recent alarm will
over-write the old one. The tool provides the
following information:
alarm code
the critical value
the date and time when the alarm was set
off
the duration of the alarm (from 1 min to 99
h and 59 min, partial if the alarm is in
progress).
The following alarm codes are available:
AL : minimum temperature alarm
AH : maximum temperature alarm
id : door microswitch input alarm
PF power failure alarm
To avoid having to memorise power failure
alarms repeatedly, disconnect the power supply
when the tool is off
If the duration of the power failure alarm is
such that it causes a clock error (code "rtc"), the
tool will not provide any information regarding the
duration of the alarm
HACCP alarms display
Make sure the keyboard is not locked.
Keep the
key pressed for 1 second: the
screen will display the letters "rtc".
Press the
key repeatedly until the letters
"LS" appear.
Press the
key: the screen will display the
code for the most recent alarm (in other words
one of the codes listed above followed by number
"1"; the greater the number that follows the code
for the alarm, the older it is). With the
9
ENGLISH
key: the
and
GB
Publicité
