Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
No hot water.
No cold water.
Water dispenser is not
dispensing water.
Alarm is beeping
continuously.
Insufficient water levels in the reservoir.
The unit is unplugged.
Kettle Feature button was not activated.
Temperature limit switch tripped.
The circuit breaker in your home is
tripped or the fuse is blown.
The unit is unplugged.
Thermostat needs to be adjusted colder.
Water shut-off valves are closed.
Water leakage detection system is
activated.
Make sure all water shut-off valves are open.
Plug in the power cord.
Activate the Kettle Feature button.
The temperature limit switch will re-set
automatically when the temperature of the
water drops.
Reset the breaker or replace the fuse.
Plug in the power cord.
Adjust thermostat between L (warm) and H
(colder) levels to achieve desired temperature.
Open all water shut-off valves.
Refer to Water Leakage Detection System
instructions in the manual.
11
Publicité
Table des Matières
